Re-profiles Cam Shaft

Re-profiles Camshaft to fit the GX160 and GX200 Engine.

When running the Re-profiled Cams it is recommended that G200 Springs (14751-883-000) are used.  As a safety precaution we also recommend that you remove the Inlet Collet and use an Exhaust Collet (14773-ZE1-000) and Exhaust Valve Rotator (14781-ZE1-000).  This will reduce the likelihood of dropping a valve.

To ensure that the adjuster locknut sits on a full thread on the Inlet Rocker we advise fitting a single 8mm washer between the cylinder head and the base of the valve rocker post to raise the post.

This is a .265" lift cam. This cam is designed for use with a standard GX160 or GX200 carburettor. Duration is 226 on the intake and 236 on the exhaust. No block clearance needed for this cam. Just drop in and go! G200 valve springs recommended for use with this cam.

Re-profiled Cam Shaft, Custom Ground .265" Lift

Part #CAM_265

Our Price: £

Stock Available:  

This is a .265" lift cam. This cam is designed for use with a standard GX270 or GX390 carburettor. Duration is 226 on the intake and 236 on the exhaust. No block clearance needed for this cam. Just drop in and go! G200 valve springs recommended for use with this cam.

Re-profiled Cam Shaft, Custom Ground .265" Lift, Modified

Part #CAM_265_MOD

Our Price: £

Stock Available: